Reconnect the battery and turn the ignition to the "On" position without cranking the engine. Listen for the fuel pump or module engagement. After 30 seconds, start the engine and let it idle. Monitor the dashboard for any Check Engine Lights. If a light appears, use your scanner to reset the system, allowing the ECU to "learn" the new RJ01228542 parameters.

The most critical step in a motorhome engine install is aligning the engine with the transmission (often an Allison 3000 or 4000 series).

The motor (often associated with ENG or Lippert/Schwintek systems) is a high-torque motor used in RV slide-out mechanisms. Below are the general installation steps for this type of in-wall slide motor. Preparation & Safety

Slide the top of the new motor into the upper notch in the column.