Stc-600 Temperature Controller Manual Pdf Instant

| Code | Parameter Name | Default Setting | Recommended Range | | :--- | :--- | :--- | :--- | | | Temperature Set Point (SV) | 25°C | Your target temp | | F2 | Differential / Hysteresis (HY) | 2.0°C | 0.5°C - 5.0°C | | F3 | Cooling Delay Protection (PT) | 3 Minutes | 0-10 min (3 min saves compressor) | | F4 | Temperature Calibration (CA) | 0.0°C | ±5°C | | F5 | Unit Selection (CF) | 0 = Celsius | 1 = Fahrenheit | | F6 | High Temperature Alarm (AH) | 99°C | Set above your max desired temp | | F7 | Low Temperature Alarm (AL) | -40°C | Set below your min desired temp |

If you're looking for a manual in PDF format, you can try the following options: Stc-600 Temperature Controller Manual Pdf

This determines how much the temperature can drift before the controller turns on. For example, if your target is 20°C and F1 is set to 2°C, the controller will turn on heating when the temp drops to 18°C and turn off at 20°C. | Code | Parameter Name | Default Setting

: Supports multiple control configurations, including compressor-only, defrost cycles, and dedicated fan management. : Parameters allow for an offset (usually -10

: Parameters allow for an offset (usually -10.0°C to +10.0°C) to correct sensor deviations. Sensor Errors