Jcb Key Code Install !!top!! -

: Turn the ignition off for at least five seconds. The new code is now recorded. Starting the Machine with a Key Code

| Symptom | Likely Cause | Action | |--------|--------------|--------| | Immobilizer light stays on | Wrong transponder type | Use JCB-approved key blank | | Light flashes rapidly | Timeout exceeded | Repeat procedure faster (within 10 sec steps) | | No response after step 5 | Key already programmed or faulty | Test key on another machine or replace blank | | "Access Denied" in software | Incorrect PIN / dealer lock | Contact JCB dealer for override | jcb key code install

: Lower the armrest and press the unlock button (often located below the keypad) to engage the hydraulics. Advanced Management & Troubleshooting : Turn the ignition off for at least five seconds

(typically part number 701/45501) into the ignition switch and turn it to Position 1 jcb key code install